Wiring harness, soft-top cover, Convertible
|
|
Wiring harness, soft-top cover, Convertible
|
|
1.
|
Remove the cover on the inside of the lid.
|
|
2.
|
Mark all connectors meticulously
before unplugging them from their components.
|
|
3.
|
Unplug the connector below the LH hinge.
|
|
4.
|
Cautiously detach the wiring harness so as not to spoil those cable ties, etc., that are to be re-used.
|
|
5.
|
Run the new wiring harness in the same way as the old one and fasten it in the same manner.
|
|
6.
|
Plug the connectors to their components. In case of doubt, check against the wiring diagrams and component lists pertaining to the system you are working on.
|
|
7.
|
Put the connector back together.
|
|
Important
|
|
Fasten the wiring harness correctly so that there is no risk of it scraping or rattling.
|
|
Check all rubber grommets to minimize the risk of leakage.
|
|
|
|
|
|
Note
|
|
Spray all the connectors with “Kontakt 61” to prevent corrosion; clean all the grounding points and apply vaseline.
|
