Input shaft speed sensor
Input shaft speed sensor |
To remove |
1. |
Put the expansion tank out of the way.
|
2. |
Remove the sensor's screw.
|
3. |
Raise the car.
|
4. |
Remove the front left wheel.
|
5. |
Remove the sensor.
|
6. |
Unplug the connector.
|
To fit |
1. |
Plug in the sensor and position it in place.
|
2. |
Put back the front wheel.
Tightening torque: 110 Nm (81 lbf ft) Lower the car to the floor. |
3. |
Tighten the sensor's retaining bolt.
Tightening torque: 6 Nm (4.5 lbf ft). |
4. |
Put back the expansion tank.
|