Fitting extra ground cable between the fifth bow mounting and cylinder
|
|
Fitting extra ground cable between the fifth bow mounting and cylinder
|
This method assumes that the following DTC have been generated: B2015 and B2016. The cause may involve the cylinder rod which does not have a sufficient ground contact. In order to maintain a stable contact, an extra ground cable can be fitted between the fifth bow mounting and cylinder.
|
1.
|
Operate the soft top to a position where the fifth bow and soft top cover are up.
|
|
2.
|
Place the ground cable on the inside of the lock clip.
|
|
3.
|
Change the pin for the new pin on the fifth bow's left cylinder.
|
|
4.
|
Open the hose clamp and fit it around the upper hydraulic hose's connection.
|
|
5.
|
Pull the ground cable under the hydraulic hose connection and under the screw. Fit the hose clamp screw.
|
Note
|
|
Fit the ground cable and the lock clip exactly as shown in the figure.
|
|
|
6.
|
Connect the diagnostic tool to the vehicle and delete any diagnostic fault codes.
|
|
7.
|
Run the soft top 5 full cycles. Check the function and that the ground cable does not get entangled.
|
