SAAB WIS ONLINE

Lock fitting/switch windscreen crossmember

Lock fitting/switch windscreen crossmember

Removing

The following describes removal of the microswitch on the left side. The right microswitch is removed using the same method.


1. Lower the soft top.

2. Remove the sun visor and the visor support.


3. Loosen the windscreen frame seal so that the bolts securing the top part of the windscreen moulding can be accessed.

4. Remove the bolts.

5. Slightly pull down the windscreen frame moulding and

6. Remove the bolts that secure the lock fitting.


7. Unplug the connector and remove the lock fitting.

8. Bend out the clips and pull out the switch.


Fitting



1. Fit the switch in the lock fitting and bend back the clips.

2. Fit the lock fitting on the windscreen frame and tighten the bolts.

3. Plug in the connector.

4. Fit the upper part of the windscreen frame moulding and then tighten the bolts.


5. Refit the windscreen frame seal. See Windscreen frame seal, CV

Use only soapy water to facilitate fitting of the seal.

6. Fit the lower part of the windscreen frame moulding.

7. Refit the sun visor and the support.

8. Connect the diagnostics tool and erase any diagnostic trouble code.