Relay, hydraulic unit
Relay, hydraulic unit |
Removing |
1.a. |
Release the rear seat backrest and fold it forward.
|
1.b. |
Remove the cover on the emergency opening valve and open the valve about one half turn
(A)
.
|
1.c. |
Unlatch the soft top from the windscreen frame.
|
1.d. |
Activate the fifth bow latch to UNLATCH using the diagnostic tool and raise the fifth bow.
|
1.e. |
Insert the wheel bolt tool through the opening in the right-hand luggage compartment trim and attach it in the drive mechanism link arm
(B)
.
|
1.f. |
Unlatch the soft top cover by pulling back on the tool until the soft top cover is lifted a few centimetres
(C)
.
|
1.g. |
Remove the tool, close the boot lid and open the soft top cover.
|
1.h. |
Carefully lower the soft top.
|
1.i. |
Close the soft top cover.
|
2. |
Release the rear seat backrest and fold it forward.
|
3. |
Remove the cover on the hydraulic unit.
|
4. |
Fold back the luggage compartment mat and remove the bolts securing the hydraulic unit.
|
5. |
Lift up the hydraulic unit and unplug the connector.
|
6. |
Press out the locking pins in the plastic rivets and remove the relay holder.
Take care not to damage the hydraulic hoses |
7. |
Remove the relay from the holder.
|
Fitting |
1. |
Fit the relay. Make sure the relay is fitted as it was earlier.
|
2. |
Fit the relay holder to the hydraulic unit. Use new plastic rivets if necessary.
|
3. |
Plug in the connectors.
|
4. |
Fit the hydraulic unit to the torsion box.
|
5. |
Replace the luggage compartment mat and refit the cover.
|
6. |
Connect the diagnostics tool and erase any diagnostic trouble codes. See
Tech 2 menu structure
.
|
7. |
Operate the soft top for 5 complete cycles. Checks its function and any DTCs.
|
8. |
Raise the rear seat backrest.
|