Tailgate handle
Tailgate handle |
1. |
Open the tailgate.
|
2. |
Remove the pull handle and the tailgate trim, see
Door trim, tailgate
|
3. |
Remove the retainer nuts (2 pcs) that secure the handle from the inside, beside the lock unit.
|
4. |
Remove the bolts that secure the ramp where the license plate lighting is fastened.
|
5. |
Remove the left rear light by removing the 3 nuts for the lamp housing, and the unplug connector in the lamp holder.
|
6. |
Remove the combined handle-lighting assembly by removing the left clip and pulling the moulding to the left until the right clip slides out of its groove.
|
To fit |
1. |
Fit the combined handle-lighting assembly by pushing the moulding against the right clip until it snaps into place and then fasten the left clip.
|
2. |
Fasten the bolts for the license plate lighting ramp.
|
3. |
Fit the left rear light. Fit the 3 nuts for the lamp housing and plug in the connector in the lamp holder.
|
4. |
Fit the nuts (2 pcs) that secure the handle from the inside, beside the lock unit.
|
5. |
Fit the pull handle to the inside of the tailgate.
|
6. |
Fit the tailgate trim, see
Door trim, tailgate
|