SAAB WIS ONLINE

Bridge spoiler, rear Viggen

Bridge spoiler, rear Viggen

Removing


1. Remove the wiper arm on the tailgate.


2. Open the tailgate and remove the trim. See Door trim, tailgate .

3. Remove the wiper motor.

4. Undo the three screws securing the spoiler in place.


5. Lower the tailgate and remove the four screws at the outer ends of the spoiler and remove the holders.

6. Close the tailgate carefully and lift the spoiler away.


7. Remove the four screws holding the spoiler together and separate its upper and lower parts.


Fitting


1. If the spoiler has been separated, screw the upper and lower parts together.


2. Open the tailgate halfway and fit the holders on the ends of the spoiler. Insert the screws.


3. Check that the spoiler is on straight. It should be parallel with the window's bottom moulding.

4. Tighten the spoiler's three retaining nuts and the screws in the outer ends of the spoiler.

5. Fit the wiper motor and plug in the connector. Fit the wiper arm.


6. Check the operation of the wiper, making sure it has the correct parking position.

7. Refit the tailgate trim. See Door trim, tailgate .