Bumper, front, Aero/Viggen
Bumper, front, Aero/Viggen |
Removing |
1. |
Raise the car.
|
2. |
Remove both spoiler shields and unplug the fog light connector.
|
3. |
Loosen the wing liners from the rear of the bumper.
|
4. |
Lower the car.
|
5. |
Open the bonnet.
|
6. |
Remove the grille.
|
7. |
Remove the right and left headlamp and combination lamp.
|
8. |
Remove the wiper motors and put them aside. Detach the washer hose secured to the bumper.
|
9. |
Remove the two bolts securing the bumper to the body.
|
10. |
Remove the temperature sensor mounted in the centre of the bumper.
|
11. |
Remove the bumper by lifting and pulling the bumper forwards so that it goes clear of the attachments in the wing and front.
|
Fitting |
1. |
Refit the temperature sensor and fit the bumper in place.
Tighten the 2 retaining bolts. Tightening torque: 39 Nm (29 lbf ft). |
2. |
Fit the wiper motors and secure the washer hose to the bumper by means of the clips.
|
3. |
Fit the right and left headlamps and the combination lamp.
|
4. |
Refit the grille.
|
5. |
Fold down the headlamp wiper arms.
|
6. |
Raise the car.
|
7. |
Carefully fold in the wing liners inside the bumper edge and fasten the wings.
|
8. |
Plug in the connectors for the fog lights.
|
9. |
Refit the spoiler shields.
|
10. |
Lower the car.
|
11. |
Close the bonnet and check the bumper fit.
|
12. |
Check the headlamp alignment and adjust if necessary.
|