Rear bumper, Viggen
Rear bumper, Viggen |
1. |
Open the tailgate.
|
2. |
Remove the door sealing moulding at the lower edge.
|
3. |
Remove the lashing eyes.
|
4. |
Fold down the luggage compartment mat.
|
5. |
Remove the scuff plate by pulling it straight up, it is fastened with clips.
|
6. |
Undo the nuts securing the bumper.
|
7. |
Remove the clips.
|
8. |
Remove the extended plastic wing liner by undoing the screws that hold it in place.
|
9. |
Bend out the front edges of the bumper against the wheel housings.
|
10. |
Remove the bumper by pulling it rearwards so that it clears the attachments.
|
Fitting |
1. |
Position the bumper on the car and screw on the nuts.
|
2. |
Bend the bumper in round the wheel housing.
|
3. |
Adjust the fit and tighten the retaining nuts.
Tightening torque: 39 Nm (29 lbf ft). |
4. |
Screw the extended plastic wing liners in place and fit the clips.
|
5. |
Fit the scuff plate by pressing it into place and securing it with the clips and then fit the lashing eyes.
|
6. |
Fold back the mat in the luggage compartment.
|
7. |
Refit the tailgate weatherstrip moulding.
|
8. |
Close the tailgate and check the bumper fit.
|