B1735
Read the instructions below then start the fault diagnostic procedure.
Symptom: Lighting for buttons and controls not working.
| B1735 |
Lighting for buttons and controls
Fault symptoms
Lighting for buttons and controls not working.Condition
The output is overload protected and is cut if the load is too high. A DTC is generated if this occurs.DTCs are not generated if the voltage is below 11V or during diagnostic communication.
Diagnostic help
Make sure the bulb is the correct rating.If a lamp with too high a rating is fitted, diagnostic trouble code B1735 can be generated.
The overload protection is reset by turning the ignition OFF and then ON.
| Important | ||
|
The DICE control module can be damaged if a bulb with incorrect rating is fitted. |
||
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
