Trip computer

Trip computer

There are two trip computer variants, SID 1 and SID 2.

The trip computers SID 1 and SID 2 have the following functions in common:

•	TEMP (outdoor temperature)

•	DTE (distance on remaining fuel).

•	FUEL (average fuel consumption)

•	SPD (average speed)

The SID 2 trip computer has the following additional functions:

•	DIST (distance to destination)

•	ARRIV (arrival time)

•	ALARM (time alarm)

•	SPD W (speed warning)

The trip computer is controlled with the buttons under the display. To be able to perform the calculations required to present the information described above, the SID unit uses the following information:

•	Time, “own” clock

•	Vehicle speed, unit km/h (mph)

•	Fuel level, unit litre (gallon)

•	Odometer reading, unit km (miles).

•	Fuel consumption since starting, unit ml

SID 1 and SID 2 functions with ignition ON

CHECKING appears on the display for approx. 4 seconds; if no CHECK message is shown, the function which was previously selected will be shown unless:

•	the outdoor temperature is in the -3°C to +3°C range, in which case the outdoor temperature will be shown.

Operation of SID 1

Select function

Select functions with the Arrow (down) and Arrow (up) buttons. Press Arrow (down) to “scroll” down and Arrow (up) to “scroll” up.

Reset function

To reset the trip computer functions, hold down the CLEAR button for more than 4 seconds. Resetting to zero is indicated by a brief acoustic signal at the same time as the text “CLEARED” appears on the display for 2 seconds.

Functions concerned are:	The display shows
Distance on remaining fuel	“x x x” km (miles)
Average fuel consumption	“- - -”
Average speed	“- - -” km/h (miles/h)

Operation of SID 2

Select function

By pressing Dot (-) or Arrow (+), all trip computer functions will start for 12 seconds.

To select from the menu of “exclusively SID 2” functions in the left-hand column, use the Dot (-) button.

To select from the right column, use the Arrow (+) button.

Reset function

To reset the trip computer functions, hold down the CLR button for more than 4 seconds. Resetting to zero is indicated by a brief acoustic signal at the same time as the text “CLEARED” appears on the display for 2 seconds.

Functions concerned are:	The display shows
Distance on remaining fuel	“x x x” km (miles)
Average fuel consumption	“- - -”
Average speed	“- - -” km/h (miles/h)
Distance to destination	0 m →

Note

The values programmed in DIST/ARRIV are not reset.

Setting the values

Select the function and then hold the SET button down for more than 1 second, whereupon an acoustic signal will be heard.

Increase or reduce the value of the selected function by using the Dot (-) or Arrow (+) button.

Confirm the setting by pressing the SET button briefly.

If the function (ALARM, SPD W) is activated, this will be indicated with an asterisk in the top row. To deactivate the function, press CLR and the asterisk will go out. Press SET to reactivate ALARM, SPD W, etc.

The set values are retained when the ignition is OFF.