Delivery pipe LHD
Delivery pipe LHD |
To remove |
1. |
Empty the clutch system (brake fluid) through the bleed nipple on the slave cylinder with
88 19 096 Bleeding equipment
.
|
2. |
Unplug the connector to the bonnet contact for the alarm if fitted.
|
3. |
Undo the main fuse box and put it to one side.
|
4. |
Undo the clip securing the deliver pipe to the master cylinder.
|
5. |
Detach the delivery pipe from the master cylinder and fit the locking clip.
|
6. |
Unscrew the delivery pipe from the slave cylinder connection.
|
7. |
Pull the delivery pipe from the clamp on the side of the engine bay.
|
8. |
Remove the pipe.
|
Fitting |
1. |
Blow clean the pipe and put it in place.
|
2. |
Press the delivery pipe into the master cylinder.
|
3. |
Connect the delivery pipe to the slave cylinder and tighten the nut. Make sure the pipe does not touch the gearbox.
Tightening torque 15 Nm (11 lbf ft). |
4. |
Press the pipe into the plastic clip.
|
5. |
Fit the main fuse box and connect the bonnet alarm contact.
|
6. |
Top up with brake fluid and bleed the system, see
.
|
7. |
Make sure all the connections are tight.
|
8. |
Test the clutch.
|