Bearing race - input shaft in gearcase
Bearing race - input shaft in gearcase |
1. |
Remove the 4 screws from the seal retainer. Keep the seal retainer, screws and shims.
|
2. |
Press out the bearing race with
87 90 800 Drift, sealing ring differential bearing
and use tool 87 92 236
as a support.
|
To fit |
1. |
Turn the gearcase and fit the bearing race in position using a plastic hammer.
|
2. |
Then press down the bearing race with
87 92 202 Sleeve
and
87 91 188 Support, removing pinion shaft
until the tool reaches the bottom of the gearcase.
|
3. |
Fit the bearing retainer with a nominal shims combination of 1.5 mm. Tighten down the bearing race alternately with the bearing retainer.
Tightening torque 38 Nm (28 lbf ft) |