SAAB WIS ONLINE

Final drive gear, differential unit

Final drive gear, differential unit


To remove


1. Remove the final drive gear bolts using an external torx and tap off the final drive gear using a plastic hammer.


To fit


Important

Do not mix old and new bolts on the same gear wheel. Always use new bolts.



1. Tap on the final gear wheel on the differential housing using a plastic hammer.

2. Fit the final drive gear with the marking towards the differential housing. Fit the new bolts and tighten alternately. Coat the bolts with 74 96 292 Thread lock . The wheel may require slight heating before fitting.

Tightening torque 20 Nm+90° (15 lbf ft+90°)