SAAB WIS ONLINE

O-ring and sealing ring in seal retainer, left-hand

O-ring and sealing ring in seal retainer, left-hand

To remove


A condition for this is that the gearbox or left-hand drive shaft has been removed.


1. Undo the five screws on the seal retainer and remove the seal retainer. Keep shims, screws and the seal retainer in a safe place.

2. Press out the sealing ring with 87 91 311 Sleeve, bearings driver shaft and Support 87 92 236.

3. Detach the O-ring with a small screwdriver or similar.



To fit


1. Press on the sealing ring with Fitting tool 87 92 657 and use Support 87 92 236.


2. Lubricate a new O-ring and carefully fit it.


3. Lubricate the seal ring.

4. Fit the seal retainer and shims with the screws. Tighten alternately.


Tightening torque 22 Nm (16 lbf ft)