Brake servo unit, LHD
Brake servo unit, LHD |
1. |
Remove the brace between the MacPherson struts.
|
2. |
Remove the master cylinder, see
.
|
3. |
Remove the vacuum hose from the brake servo.
|
4. |
Undo the main fuse box and place it to one side to improve accessibility.
|
5. |
Remove the brake servo retaining nuts from the bracket.
|
6. |
Remove the rubber gaiter from the bulkhead partition and pull it towards the servo unit.
|
7. |
Remove the clip on the pushrod and lift out the brake servo unit.
|
To fit |
1. |
Place the brake servo unit into the bracket and tighten the four retaining nuts.
|
2. |
Fit the clip on the pushrod and the rubber gaiter to the bulkhead partition.
|
3. |
Fit the main fuse box in place.
|
4. |
Fit the vacuum hose.
|
5. |
Fit the master cylinder, see
.
|
6. |
Fit the brace between the MacPherson struts.
|
7. |
Bleed the brake system. See
Bleeding the brake system
.
|