B2446, 2447, B2448, B2449
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Airbag warning lamp on.
|
B2446, 2447, B2448, B2449
|
B2446
Passenger Belt Tensioner. Open Circuit
B2447
Passenger Belt Tensioner. Short to Ground
B2448
Passenger Belt Tensioner. Short to B+
B2449
Passenger Belt Tensioner. Resistance too Low
Fault symptoms
Airbag warning lamp on.
Conditions
The following conditions are applicable to the respective diagnostic trouble codes:
B2446
•
|
The resistance measured by the control module is greater than 3.9 Ω for 10 seconds
|
•
|
The resistance measured by the control module is greater than 225 Ω for 160 ms
|
Diagnosis is not performed if DTC B2447 or B2448 has been generated.
B2447
•
|
The voltage applied to control module pin 15 is lower than 1.5 V for 1.25 seconds
|
B2448
•
|
The voltage applied to control module pin 45 is higher than 3.5 V for 1.25 seconds
|
B2449
•
|
The resistance measured by the control module is lower than 1.4 Ω for 20 seconds
|
Diagnosis is not performed if DTC B2447 or B2448 has been generated.