Section of inner sill reinforcement, CV
|
Section of inner sill reinforcement, CV
|
1.
|
Mount the car in an alignment bench with measuring fixture and cross-measure as necessary.
|
2.
|
Remove the junction plate at the front wheel housing.
|
3.
|
Cut the sill reinforcement as illustrated.
|
4.
|
Grind down the welds securing the sill reinforcement.
|
5.
|
Knock away the sill reinforcement and align any deformed metal.
|
6.
|
Cut the spare part so that it overlaps the joint by approximately three centimetres.
|
7.
|
Fit the spare part and fixate with a couple of welding clamps.
|
8.
|
Cut through the new sill reinforcement and the body at the same time so that the joint can be butt welded.
|
9.
|
Remove the new sill reinforcement and grind the surfaces to be welded.
|
10.
|
Grind the surfaces to be welded on the body.
|
11.
|
Put the new sill reinforcement in place and secure it with some welding clamps.
|
12.
|
Seam weld the sill reinforcement in place.
|
13.
|
All-weld the joint on the sill reinforcement.
|
14.
|
Apply primer to all bare metal surfaces. Use Standox 1K Fullprimer.
|
15.
|
Seal joints and sheet metal flanges with sealant. Use Terostat 1K-PUR.
|
16.
|
Apply anti-corrosion agent to internal surfaces after painting. Use Terotex HV 400.
|