Door handle, front door
Door handle, front door |
To remove |
1. |
Open the door.
|
2. |
Remove the door trim, see
Door trim, front door
.
|
3. |
Remove the plastic water barrier.
|
4. |
Remove the pull rod between the door handle and door lock from the door side and leave it suspended.
|
5. |
Loosen the guide channel lower retainer bolt and angle out the channel without releasing the retainer at the top (plug-in retainer).
|
6. |
Remove the pull rod, between the lock cylinder and the door lock, from the lock.
|
7. |
Remove the lock nut with plate from the rear of the door handle.
|
8. |
Guide out the push rod, between the exterior handle and the lock, from the lock.
|
9. |
It may be necessary to remove the lock, 3 bolts.
|
10. |
Angle the handle out of the door.
|
11. |
Pull of the retainer clip securing the microswitch and unhook it.
|
To fit |
Fit in reverse order.
Important | ||
Make sure the water drainage plastic is tight against the inner panel of the door and that it is not damaged. |
||