Door lock, rear doors
Door lock, rear doors |
To remove |
1. |
Open the door.
|
2. |
Remove the door trim, see
Door trim, rear door
.
|
3. |
Remove the plastic water barrier.
Lift out the collision block to increase accessibility. |
4. |
Remove the pull rod, between inside handle and lock, from the lock.
|
5. |
Remove the pull rod between lock button and lock, from the lock.
|
6. |
Remove the retaining screw for the rear guide channel.
|
7. |
Remove the three retainer screws from the lock.
|
8. |
Remove the complete lock unit.
|
9. |
Unplug the connector for the central lock motor.
|
10. |
Remove the central lock motor from the lock.
|
To fit |
Fit in reverse order.
Check the door handle clearance against the lock. Adjust if needed, by adjusting up/down the opening rod adjusting screw until it is up against the lock opening lever.
Important | ||
Make sure the water drainage plastic is tight against the inner panel of the door and that it is not damaged. |
||
Note | ||
It must be possible to feel the clearance in the door handle, the lock opening lever must not be actuated in the resting position. |