Front doors
Front doors |
To remove |
1. |
Unplug the wiring harness connector in the door (bayonet fitting).
|
2. |
Remove the door stop from the A-pillar.
|
3. |
Remove the hinge bolts.
|
To fit |
Fit in reverse order.
Tightening torque:
Hinge bolts: 47 Nm (35 lbf ft).
Note | ||
On order to get the correct fit between the door and wing, it may be necessary to lift slightly at the rear edge of the door. This applies especially to the 3-D model. |
Connect the diagnostics tool and erase any diagnostic trouble code.
Adjustment |
Adjust the door, see Adjustment of front and rear doors