Fitting the steering wheel sealing strip
|
Fitting the steering wheel sealing strip
|
Warning
|
Read the safety and handling instructions for the Airbag (SRS) before starting work.
|
|
|
|
|
1.
|
Turn the ignition key to the OFF position and remove the key.
|
2.
|
Remove the airbag-module, two plugs and two screws.
|
3.
|
Lift out the module and detach the cable connections.
|
4.
|
Clean the surface of grease and dirt, use
30 15 815 Cleaning agent
.
Fit the sealing strip level with the inner edge as per illustration. Press the strip down well.
Note
|
It is important that the strip finishes up totally tight with the steering wheel cover so that air cannot leak out.
|
|
5.
|
Connect the cables to the airbag module.
|
6.
|
Fit the module, the two screws. Make sure that the strip does not protrude over the edge. Fit the plugs into the screw holes.
|
7.
|
Start the engine and check that the airbag warning lamp does not indicate a fault.
|
|
•
|
Carry out troubleshooting if the lamp indicates a fault in the airbag system.
|
8.
|
Check the signal function.
|