Rear side trim, CV
Rear side trim, CV |
To remove |
1. |
Operate the soft top as shown in the illustration.
|
2. |
Remove the rear seat cushion.
|
3. |
Remove the bolt which secures the front seat belt to the floor.
|
4. |
Remove the scuff plate.
|
5. |
Remove the cover and remove the screw which secures the trim to the B-pillar.
|
6. |
Remove the plastic screws which secure the trim to the lower edge.
|
7. |
Fold the backrest forward.
|
8. |
Remove the bolt and plastic screw securing the trim at the rear edge.
|
10. |
Remove the seat belt from the side trim.
|
11. |
Remove the lamp connector and remove the side trim.
|
To fit |
1. |
Connect lamp connector. Ensure that the lamp is firmly and correctly seated in the guide cover.
|
2. |
Insert the seat belt through the strap guide.
|
3. |
Fit the upholstery and press in the clip into the upper rear corner. Make sure that the rubber seal fits correctly to the trim.
|
4. |
Tighten the bolt and fasten the plastic screws that secure the side trim to the rear edge.
|
5. |
Raise the backrest.
|
6. |
Fasten the plastic clips that secure the trim at the bottom.
|
7. |
Tighten the bolt that secures the trim to the B-pillar and then press on the cover.
|
8. |
Fit the sill scuff plate.
|
9. |
Check that the seat belt is not twisted and then tighten the bolt that secures the seat belt to the floor.
Tightening torque: 45 Nm (33.3 lbf ft) |
10. |
Refit the seat cushion in the rear seat.
|