SAAB WIS ONLINE

Rear seat belts, 3D/5D

Rear seat belts, 3D/5D

To remove


1. Raise the rear seat, both cushions.


2. 5-door: Remove the scuff plates on the right and left-hand rear sills (fastened with clips).

3. Remove the seat-belt anchorages on the sides, they are fastened to the side impact protection.

4. Remove the centre belt anchorage.

5. Remove both the rear head restraints.

6. Remove the head restraint mountings from the belt member. Release the catch inside the sleeve with a screwdriver and tap out the mounting from below.

7. Undo the centre cover on the belt member, it is fastened with clips.

8. Remove the lock handle for the 40% section.


9. Remove the right-hand cover and unhook the cable from the lock arm.

10. Remove the belt member release handle and undo the cable from the handle.

11. Undo the left-hand cover on the belt member.

12. Remove the covers from the seat belts.

13. Remove the inertia reel retaining bolts.


To fit



1. Fit the inertia reel retaining bolts.

Tightening torque 38 Nm (28 lbf ft).

2. Refit the covers onto the seat belts.

3. Refit the left-hand cover onto the belt member.

4. Fit the cable onto the handle and refit the belt member release handle.

5. Hook on the cable to the lock arm and fit the right-hand cover.

6. Fit the lock handle to the 40% section.

Note

Make sure the cable runs correctly in the belt member release handle and check that the belt member can be opened and closed properly.


7. Fasten the centre cover to the belt member.

8. Fit the head restraint mountings into the belt member.

9. Fit both the rear head restraints.

10. Fit the centre belt anchorage.


11. Fit the side belt anchorages, they are fastened to the side impact protection.

12. 5-door: Fit the scuff plates to the right and left-hand rear sills (fastened with clips).

13. Lower both the rear seat cushions.