SAAB WIS ONLINE

Road test

Road test


The road test is an important part of the service programme. Check the function of the various components and systems as described below.

SE, US and CA only . OBD II specified car: Check for remaining faults that may cause a CHECK ENGINE warning.


Road testing should continue for at least 15 minutes at varying engine loads.


Functionality checks


Ignition switch: Check that the gear lever lock operates satisfactorily and that the key is easy to insert and remove.

Engine: Operation and noise level. If a turbo gauge is available, make sure that the charge pressure is normal during acceleration (the dial should go up to the red zone).

Clutch: Check the clutch disengagement and engagement positions.

Manual gearbox: Check gearbox operation and noise level.

Wheels: Check wheel balance and wheel roundness.

Steering: Check the straight-ahead position of the steering wheel, directional stability and operation of the power steering system.

Instruments and indicator lamps: Check the operation of instruments and indicator lamps.

Brakes: Check brake pedal travel, handbrake lever travel (4-6 notches), and the efficiency of the brakes and handbrake.

Cruise Control: Check the functionality of the Cruise Control system.

Heating and ventilation unit: Check the operation of the A/C system and controls. When the outdoor temperature is so low that the A/C cannot be turned on, check its operation indoors.

Inspect the surface of the steering wheel centre pad (airbag module) and passenger airbag, if fitted, for external damage.

Wipers and washers: Check the washer jet pattern and wiper operation on the windscreen and, if relevant, the rear window.

Check that the clock shows the right time.


Bear in mind the customer's expectations!

Wipe the steering wheel and gear lever clean and make sure that all other traces of pre-delivery inspection and service work have been removed.