Replacement of balancer-shaft bearings
| Replacement of balancer-shaft bearings |
| To remove |
| 1. |
Remove the blanking-off washer.
|
|
| 2. |
Insert
83 94 470 Press tool, balancer shaft bearing
from the flywheel end and connect the pull rod with a nut.
|
|
| 3. |
Carefully remove the bearing by slowly tightening the nut.
|
|
| To fit |
| 1. |
Clean the bearing surface in the cylinder block.
|
|
| 2. |
Put the bearing on
83 94 470 Press tool, balancer shaft bearing
.
|
|
| 3. |
Insert the fitting tool from the flywheel end and connect the pull rod with nut.
|
|
| 4. |
Tighten the nut until the marking on the tool is aligned with the edge of the hole for the blanking-off washer. The bearing is now in the correct position.
|
|
| 5. |
Dismantle and remove the tool.
|
|
| 6. |
Make sure the oilway is open.
|
|
| 7. |
Fit a new blanking-off washer.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
