B1424

Read the instructions below then start the fault diagnostic procedure.

Symptom: Poor heating of cabin Stop the heater if it is used Heater does not start

B1424

Fault symptoms

Poor heating of cabin

Stop the heater if it is used

Heater does not start

Conditions

Heater is activated.

Voltage supply is below 10.2 V for 25 seconds.

Diagnostic help

The voltage to the heater can be read using the diagnostics tool.

The heater is provided with extra cabling and connector which is isolated from the ordinary cabling from the heater. This cabling and connector is not used but is connected to the control module, therefore always check that this cabling is undamaged before beginning fault tracing.

In the ordinary cabling between the heater and the 8-pin connector, there is an extra light green lead that is cut and is not used.