SAAB WIS ONLINE

Front oxygen sensor (B235R, B205L/R)

Front oxygen sensor (B235R, B205L/R)

Dismantling


1. Remove the top engine cover


2. Detach the oxygen sensor connector from the holder.

3. Remove the bypass pipe and heat shield.


4. Cut the cable tie for the oxygen sensor and pull out the cables

Important

The leads must not be twisted. The oxygen sensor is highly sensitive to knocks and blows and must be handled with care.


5. Release the oxygen sensor from the turbo outlet pipe


To fit


1. Coat the oxygen sensor's threads with Molycote 1000 (30 20 971) to prevent binding.

Important

The oxygen sensor is sensitive to knocks and blows and must be handled with care. It is important to ensure that the connection between it and the nipple is gastight.


Important

Chemicals such as contact spray and grease must not come into contact with the oxygen sensor connectors.


2. Fit the oxygen sensor.

Tightening torque: 55 Nm (41 lbf ft)


3. Run the cable forward and plug in the connector.


4. Secure the cable to the water pipe with a cable tie.

5. Fit the heat shield and bypass pipe.

6. Fit the top engine cover.