Rear oxygen sensor (B235R, B205L/R)
|
|
Rear oxygen sensor (B235R, B205L/R)
|
|
1.
|
Remove the top engine cover.
|
|
2.
|
Detach the connector from the holder.
|
|
3.
|
Cut the cable tie and pull out the cable.
|
|
5.
|
Pull down the cable and remove the oxygen sensor.
|
Important
|
|
The leads must not be twisted. The oxygen sensor is highly sensitive to knocks and blows and must be handled with care.
|
|
|
|
|
1.
|
Coat the oxygen sensor's threads with Molycote 1000 (30 20 971) to prevent binding.
|
Important
|
|
The oxygen sensor is sensitive to knocks and blows and must be handled with care. It is important to ensure that the connection between it and the nipple is gastight.
|
|
|
|
Important
|
|
Chemicals such as contact spray and grease must not come into contact with the oxygen sensor connectors.
|
|
|
|
|
2.
|
Fit the oxygen sensor.
Tightening torque: 55 Nm (41 lbf ft)
|
|
3.
|
Run the cable as far up as possible. Lower the car.
|
Important
|
|
Watch out for sharp edges, hot components, etc.
|
|
|
|
|
4.
|
Run the cable forward and plug in the connector.
|
|
5.
|
Secure the cable to the water pipe with a cable tie.
|
|
6.
|
Fit the top engine cover.
|
