Accelerator pedal
Accelerator pedal |
1. |
Remove the resonating chamber or the cover over the intake manifold.
|
2. |
Undo the clips and unhook the throttle cable from the link arm and cable mounting.
|
3. |
Remove the lower section of the dashboard and unhook the throttle cable from the accelerator.
|
4. |
Unhook the accelerator pedal's return spring.
|
5. |
Remove the clips and the bushes.
|
6. |
Extract the accelerator pedal and remove the return spring.
|
To fit |
1. |
Fit the return spring and introduce the accelerator pedal.
|
2. |
Fit the bushes and fasten the clips.
|
3. |
Hook the return spring in place and hook the throttle cable onto the accelerator pedal.
|
4. |
Hook the throttle cable onto the link arm.
|
5. |
Manual gearbox:
Place a 5 mm (0.2 in) spacer on the pedal stop and press the pedal down against the spacer. Turn the adjusting sleeve until the throttle valve is fully open and then turn it back half a turn. Automatic Transmission: Press the pedal down until it rests on the kickdown switch. Turn the adjusting sleeve until the throttle valve is fully open and then turn it back half a turn. Be careful to avoid pressing the switch down. |
6. |
Release the accelerator and adjust the idling position of the throttle cable by means of the adjusting screw in the upper part of the pedal. The cable should then have a small amount of free play.
|
8. |
Fit the lower section of the dashboard.
|