SAAB WIS ONLINE

P0140

Read the instructions below then start the fault diagnostic procedure.

Symptom: CHECK ENGINE. Misfiring can occur before trouble code is generated.

P0140


O2S Circuit. No Activity Detected. Sensor 2.


Fault symptoms


CHECK ENGINE.

Misfiring can occur before trouble code is generated.


On-Board Diagnostics

Type of diagnosis:


- Once per driving cycle. Interrupted when fault criteria fulfilled or OK reported. Restarts next driving cycle.


Enable criteria


- General condition for this diagnostic trouble code: Atmospheric pressure must exceed 72 kPa as well as coolant and intake air temperature must exceed -7°C.

- Engine running. Closed loop active. Coolant temperature above 70°C. Sensor pre-heating active. Vehicle speed above 0. A counter accumulates the time during which all the conditions are fulfilled. Another counter accumulates changes in sensor voltage.


Fault criteria


- Accumulated voltage change less than 500 mV when time counter reaches 500 s.


Dependents


- P0116, P0117, P0118, P0501, P0502, P1141 and P1142.


System reaction to a fault


- Transition adaptation of closed loop is blocked.


OK report


- P0140 diagnosis performed once and fault criteria not fulfilled. Fault criteria for P0138 not fulfilled.


Fault handling: (For more information, see .)


- Type III.


Diagnostic help

Fault diagnosis concerns an electrical fault in connecting leads or in the sensor.

Functions in the diagnostic tool related to the fault:


Diagnostic status for the diagnosis.

Oxygen Sensor Value, unit V.


For more information, see .

Note

The oxygen sensor receives reference oxygen from the surrounding air via the connecting cables. For this reason, electrical contact spray or grease must not be used on the oxygen sensor connector.


Checking the wiring

Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short circuits. Observe the multimeter, diagnostic tool or test lamp during the check.