SAAB WIS ONLINE

Antenna/dummy antenna, fixed (3D/5D)

Antenna/dummy antenna, fixed (3D/5D)

Note

Cars from model year 2001 and VIN 12046130 without preparation for handsfree have a dummy antenna mounted on the roof. For more information, see Telephone system .


To remove

If unsure as to whether or not the car is prepared for handsfree, perform a check. Use a torch to shine through the microphone mesh. On cars prepared for handsfree, a black microphone is clearly seen behind the mesh. On cars not prepared for handsfree, there is empty space behind the mesh.


1. Remove the parcel shelf.

2. Fold the rear seat backrest forward.

3. Remove the speaker grilles in the parcel shelf on the RH and LH sides.


4. Remove the C-pillar trim on the RH and LH sides.

5. Remove the rear courtesy handles on the RH and LH sides.


6. Remove the two plastic clips and lower the headlining.

Note

Be careful so as not to break the headlining.


7. Disconnect any wires connected to the antenna.


8. Loosen the nut at the antenna base and remove the antenna.


To fit



1. Fit the antenna and tighten the nut.

Tightening torque: 3.0 Nm (2.2 lbf ft).

2. Connect any wires to the antenna.

3. Lift the headlining and fasten with the plastic clips.


4. Fit the rear courtesy handles on the RH and LH sides.

5. Fit the C-pillar trim on the RH and LH sides.


6. Fit the speaker grilles in the parcel shelf on the RH and LH sides.

7. Raise the rear seat backrest.

8. Fit the parcel shelf.