P0730
Read the instructions below then
start the fault diagnostic procedure.
Symptom:
Gear Function. Mechanical Fault.
Fault symptoms
CHECK GEARBOX warning lamp on.
TCM in limp-home mode.
Slippage in the transmission.
Conditions
The difference between input shaft speed and output shaft speed (speed of the car) is more than 10% above the gear ratio for more than 5 seconds.
Diagnosis will not be performed if:
1.
|
The TCM is in limp-home mode.
|
2.
|
Car speed is below 25 km/h.
|
3.
|
The selector lever is in P, R or N.
|
4.
|
The accelerator position is less than 10%.
|
5.
|
The fluid temperature is lower than 20°C.
|
6.
|
Less than 10 seconds has elapsed since shifting occurred.
|
7.
|
Engine speed is below 400 rpm.
|
8.
|
Diagnostic trouble code 0717 or 0722 has been generated.
|
Diagnostic help
The control module calculates the ratio between input and output shaft speed. For each gear there is a definite relationship, depending on the ratio. The fault indicates a mechanical malfunction. Wear in the transmission may be the cause of abrupt shifting and an inoperative Lock-up function.