Soft top cover hinges
Soft top cover hinges |
Removing |
1. |
Loosen and fold down the luggage compartment upholstery. Place some protection on the boot lid.
|
2. |
Measure the distance on the hinge to the upper nut.
|
3. |
Unplug the connectors for the microswitches and the latch motor. Cut off the cable ties.
|
4. |
Remove the nuts and bolts securing the soft top cover to the hinges. Lift away the top cover.
|
5. |
Remove the soft top cover seal.
|
6. |
Loosen the soft top storage from the edge.
|
7. |
Loosen the outer end on the hinge springs using an Apex screwdriver without Torx bit or a suitable pipe.
|
8. |
Remove the wiring harness from the left hinge.
|
9. |
Open the boot lid.
|
10. |
Mark the position of the left hinge on the body and remove the left hinge.
|
11. |
Lift away the rod with the springs.
|
12. |
Mark the position of the right hinge on the body and remove the bolts securing the hinge.
|
13. |
Pull out the hinge from the joint.
|
Fitting |
1. |
Press the right hinge in the joint and adjust according to marking. Fasten the hinge.
|
2. |
Fit the rod with the springs.
|
3. |
Fit the left hinge and tighten according to markings.
|
4. |
Close the boot lid and fit the springs using an Apex screwdriver without the Torx bit or a suitable pipe. Fit the wiring harness on the left hinge.
|
5. |
Fit the storage bag on the sheet metal flange and press the soft top cover seal in place.
|
6. |
Fit the soft top cover.
|
7. |
Plug in the connectors and fit new cable ties.
|
8. |
Lower the soft top cover and open the boot lid. Refit the luggage compartment upholstery.
|
9. |
Connect the diagnostics tool, erase any diagnostic trouble codes.
|