Side window, rear door

Side window, rear door

To remove

1.	Lower the window completely.

2.	Remove the door trim, see Service Manual, 8:2 Interior Equipment.

3.	Remove the plastic water deflector.

4.	Remove the cover (secured in guides in the guide channel and clips).

5.	Remove the internal window seal by prying up the rear edge of the seal with a large flat screwdriver and pull up the seal by hand.

6.	Remove the external window seal.

7.	Loosen the window frame seal from the rear guide channel and lift it out of the door.

8.	Loosen the pull bar, located between the door handle and door lock, from the door side and leave it suspended.

9.	Remove the rear guide channel by loosening the retaining screw and angle it out upwards.

10.	Remove the window glass by lifting at the rear edge and guide it away from the window lift.

11.	Lift out the glass by moving it inwards from the window frame.

To fit

1.	Fit the window glass by angling the front edge and guide it down onto the window lift.

2.	Fit the rear guide channel by pressing it down into the window opening and angle it into position above the pull bars and tighten it.

3.	Press the pull bar into position between the door handle and door lock.

4.	Press the window frame seal onto the rear guide channel. Apply vaseline to the rear of the seal.

5.	Fit the internal window seal by pressing it into place by hand, it may be necessary to use a rubber mallet.

6.	Fit the external window seal.

7.	Fit the cover, press it into position by hand.

8.	Fit the plastic water barrier.

9.	Fit the door trim, see Service Manual, 8:2 Interior equipment.

10.	Raise the window.