Luggage compartment trim, 5D/3D
|
|
Luggage compartment trim, 5D/3D
|
|
1.
|
Remove the floor mat by undoing the clips at the front of the mat.
|
|
2.
|
Remove the scuff plate, see Scuff plate, luggage compartment,
To remove
.
|
|
3.
|
Undo the clips securing the trim at the door opening.
|
|
4.
|
Fold forward the rear seat and detach the loudspeaker frame by removing the loudspeaker grille and undoing the pin bolt and retaining screws.
|
|
5.
|
Put back the backrest and remove the 40% section by undoing it from the belt member and folding it forwards. Remove the bracket at the long-load opening, pull out the backrest joint from the sleeve, undo the upholstery stretcher and lift out the backrest.
|
|
6.
|
Bend up the bracket for the backrest upholstery stretcher and undo the luggage compartment trim from the bracket.
|
Fit in reverse order.
VIN 12000073-12000130 and 17000027-17000089, if new mat being fitted:
Remove the foam block on the right-hand side of the luggage compartment. Cut off the weld studs as close to the panel as possible.
See also Scuff plate, luggage compartment,
To fit
.
