Luggage compartment trim, CV
|
Luggage compartment trim, CV
|
1.
|
Remove the scuff plate.
|
2.
|
Remove the clips securing the trim at the sides.
|
3.
|
Loosen the luggage compartment seal.
|
4.
|
Unplug the connector for the luggage compartment lighting.
|
5.
|
Remove the clips securing the floor mat and remove it.
|
6.
|
Remove the bolt that secures the load retention eye.
|
7.
|
Remove the clips that secure the front ends of the trim. Remove the trim.
|
VIN 17000027-17000089, if new mat being fitted:
Remove the foam block on the right-hand side of the luggage compartment. Cut off the weld studs as close to the panel as possible.
1.
|
Fit the trim and fasten the clips at the front ends.
|
2.
|
Fit the load retention eye and tighten the bolt.
Tightening torque: 25 Nm (18.5 lbf ft)
|
3.
|
Fit the floor mat and fasten the clips.
|
4.
|
Plug in the connector for the luggage compartment lighting.
|
5.
|
Fasten the clips securing the trim at the sides.
|
6.
|
Fit the luggage compartment seal.
|
7.
|
Refit the scuff plate.
|