Camshaft cover
| Camshaft cover |
| To remove |
| 1. |
Remove the upper engine cover.
|
|
| 2. |
Remove the turbocharger delivery pipe from the camshaft cover and turbocharger. Disconnect the crankcase ventilation hose from the timing cover. Plug the turbocharger inlet.
|
|
| 3. |
Undo the rear wiring harness mounting from the camshaft cover. Unplug the connector for the pressure/temperature sensor.
|
|
| 4. |
Disconnect the coolant pipe mounting from the camshaft cover.
|
|
| 5. |
Carefully unhook the fuel pipes from the camshaft cover.
|
|
| 6. |
Remove the camshaft cover.
|
|
| To fit |
| 1. |
Clean any gasket remains from the sealing surfaces of the camshaft cover. Fit a new gasket to the camshaft cover. Apply
83 95 691 Flange sealant
to the sealing surface as illustrated.
|
|
| 2. |
Fit the camshaft cover to the cylinder head and tighten the bolts.
Tightening torque 8 Nm (6 lbf ft) |
|
| 3. |
Fit the coolant pipe mounting to the camshaft cover.
|
|
| 4. |
Fit the rear wiring harness mounting to the camshaft cover. Plug in the connector for the pressure/temperature sensor.
|
|
| 5. |
Refit the fuel lines to the camshaft cover.
|
|
| 6. |
Remove the plug and fit the turbocharger delivery pipe to the turbocharger and camshaft cover.
|
|
| 7. |
Connect the crankcase ventilation hose to the camshaft cover.
|
|
| 8. |
Fit the upper engine cover.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
