Pressure monitor, engine oil (44)

/ 9-3 (9440) / 2003 / 2. Engine / 4-cylinder diesel / Engine management system PSG16 / Adjustment/replacement / Pressure monitor, engine oil (44)

To remove

1.	Raise the car and remove the lower engine cover.

2.	Unplug the oil pressure sensor.

3.	Place a suitable receptacle under the engine and remove the engine oil pressure sensor.

To fit

1.	Fit the engine oil pressure sensor with a new seal. Tightening torque 30 Nm (22 lbf ft)

2.	Plug in the sensor connector and wipe away any oil spills.

3.	Fit the lower engine cover and lower the car.

4.	Check the oil level. Top up if necessary.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.