SAAB WIS ONLINE

The diagnostic tool shows "ICM cannot be contacted on any bus".

Read the instructions below then start the fault diagnostic procedure.

Symptom: The diagnostic tool shows "ICM cannot be contacted on any bus".

ICM cannot be contacted on any bus.


Fault symptom

The diagnostic tool shows "ICM cannot be contacted on any bus".

Diagnostic help

Communication with CIM is necessary for Tech 2 to be able to communicate with all systems.

The Diagnostic instrument main menu "All systems/Read configuration" shows a list of those systems with which the vehicle in question was equipped before the fault was detected.

The current status of each system is shown to the right.

"OK" if control module communicates correctly.

"MISSING" if control module is not on the bus.

"ADDED" if the control module has not yet been added.

"NOT EQUIPPED" indicates that the control module is not fitted to the vehicle.

NOTE: applies before reset of bus configuration.

____________________________________

Functions in the diagnostic tool related to the fault

Read / Reset Bus Configuration
Read / Clear Bus Off Counter
Response Test

Checking the wiring harness

IMPORTANT

Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.