Starter motor, 4-cyl diesel
|
Starter motor, 4-cyl diesel
|
1.
|
Park the car on a lift.
|
2.
|
Remove the battery cover.
|
3.
|
Disconnect the negative battery cable.
|
4.
|
Remove the pressure regulator bracket from the turbocharger and detach the hose.
|
5.
|
Move the pressure regulator aside.
|
6.
|
Remove the starter motor heat shield.
|
7.
|
Detach the generator connecting cables.
|
8.
|
Unplug the oil pressure sensor connector.
|
9.
|
Detach the starter motor connecting cables.
|
10.
|
Remove the cable duct retaining bolts.
|
11.
|
Lift up the cable duct and put it aside.
|
12.
|
Remove the lower screw of the rear stay and loosen the upper one slightly.
|
14.
|
Remove the lower cover.
|
15.
|
Remove the bracket from the catalytic converter.
|
16.
|
Remove the screws of the intermediate shaft bearing bracket and put the bearing bracket to the side.
|
17.
|
Remove the lower screw of the starter motor.
|
18.
|
Lower the car to the floor.
|
19.
|
Remove the upper screw of the starter motor.
|
20.
|
Lift out the starter motor.
|
1.
|
Clean the starter motor contact surfaces and electrical contacts and apply Vaseline.
|
2.
|
Place the starter motor in the correct position.
|
3.
|
Loosely fit the upper screw of the starter motor.
|
4.
|
Loosely fit the lower screw of the rear stay.
|
6.
|
Fit the lower screw of the starter motor.
Tightening torque 47 Nm (35 lbf ft)
|
7.
|
Fit the intermediate shaft bearing bracket.
|
8.
|
Fit the bracket to the catalytic converter.
|
9.
|
Fit the lower cover.
|
10.
|
Lower the car to the floor.
|
11.
|
Tighten the upper screw of the starter motor.
Tightening torque 47 Nm (35 lbf ft)
|
12.
|
Tighten the screws of the rear stay.
|
13.
|
Place the cable duct in the correct position.
|
14.
|
Clean, apply Vaseline and connect the starter motor connecting cables.
|
15.
|
Fit the cable duct retaining bolts.
|
16.
|
Clean, apply Vaseline and connect the generator connecting cables.
|
17.
|
Plug in the oil pressure sensor connector.
|
18.
|
Fit the starter motor heat shield.
|
19.
|
Fit the pressure regulator bracket to the turbocharger and fit the hose.
|
20.
|
Connect the negative cable of the battery.
|
21.
|
Fit the battery cover.
|