SAAB WIS ONLINE

(440-2425 ed. 3) Automatic transmission, springiness in drive and jerkiness with shift up

Symptom: The automatic transmission is springy in drive with shift up from 2nd to 3rd gear.

TECHNICAL SERVICE BULLETIN
Bulletin Nbr: 440-2425 ed. 3
Date: ........... Januari 2004
Market: US
Automatic transmission, springiness in drive and jerkiness with shift up

Cars affected

Saab 9-3 (9440) M03 with automatic transmission and engine alternative B207E/L/R

Saab 9-3 (9440) M04 with automatic transmission and engine alternative B207E/L up to and including Vehicle Identification Number 41015759

Saab 9-3 (9440) M04 with automatic transmission and engine alternative B207R up to and including Vehicle Identification Number 41015764

Background

With the shift up from 2nd to 3rd gear, the automatic transmission can be springy in drive for a short period. In connection with this, the engine speed increases and shifting ends with a small amount of jerkiness.

This is due to the transmission oil pressure decreasing during certain conditions to a level which is too low, which means that its clutches are not holding together firmly enough.

The fault most often occurs when the driver has driven constantly in 5th gear at a speed between 90-120 km/h for approx. 30 minutes and has then made a stop or a reduction in speed to less than 30 km/h. When a subsequent shift from 2nd to 3rd gear takes place the above can occur.

In the case of customer complaint the following procedure must be undertaken.

Symptom description

The automatic transmission is springy in drive with shift up from 2nd to 3rd gear.



Procedure

Reprogram TCM using the diagnostic tool and TIS2000 version 2003-3 (update 5) or later. See WIS - General - TIS2000 - Technical description - Service Programming System.

After reprogramming, adaptation of the gearbox must be performed. See WIS - Transmission - Automatic gearbox - Adjustment/Replacement - Adaptation, resetting.

Warranty/Time Information

In the case of customer complaint and if the car is within the warranty period , use the following information to fill out the claim:

Failed Object: 44531

Fault/Reason code: 08

Location code: 09 (US: 9)

Warranty type: 56 (US:01)

Repair/Action code: 05

Labour Operation (US): 44531-03

Labour Operation (CA): K5364

Time including adaptation: 0.6 hr.