Impact sensor, front (332FL, 332FR)
|
|
Impact sensor, front (332FL, 332FR)
|
Warning
|
|
|
|
|
|
|
|
2.
|
Remove the impact sensor's connector.
|
|
3.
|
Dismantle the impact sensor by loosening the screws a few turns. Press together the locking clips on the inner part of the sensor. Press the outer part of the sensor towards the centre of the car and pull out the sensor.
|
|
1.
|
Fit the impact sensor by placing the sensor in position. Pull out the outer part of the sensor to the right position. Tighten the screws.
Tightening torque 6 Nm (4 lbf ft)
|
|
2.
|
Connect the impact sensor's connector.
|
|
4.
|
Turn ON the ignition and check the airbag system and control module using the diagnostic tool as follows:
Connect the diagnostic tool to the data link connector under the dashboard. Delete any diagnostic trouble codes.
Turn the ignition OFF and then ON again. Wait at least 1 minute with the ignition on.
Check whether a diagnostic trouble code is shown:
If a diagnostic trouble code is shown:
Carry out fault diagnosis according to the instructions under respective trouble codes.
If a diagnostic trouble code is not shown:
The assembly was successful. Disconnect the diagnostic tool.
|
