Air distribution flap stepping motor
| Air distribution flap stepping motor |
| To remove |
| 1. |
Remove the
glove box
.
|
|
| 2. |
Dismantle the screws from the air distribution flap stepping motor.
|
|
| 3. |
Dismantle the stepping motor's connector by pressing in the lock and pulling out the connector.
|
|
| To fit |
| 1. |
Connect the stepping motor's connector. Make sure the connector locks correctly.
|
|
| 2. |
Fit the screws on the air distribution flap stepping motor.
|
|
| 3. |
Refit the
glove box
.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
