Mixed air damper stepping motor

/ 9-3 (9440) / 2003 / 8. Body / Climate system / Manual Climate Control, MCC / Adjustment/replacement / Mixed air damper stepping motor

To remove

1.	Dismantle the floor console's front side panel.

2.	Dismantle the driver's acoustic insulation .

3.	Remove the screws from the stepping motor.

4.	Dismantle the stepping motor's link arm from the heating and ventilation unit's link arm.

5.	Remove the stepping motor's connector.

6.	Lift out the mixed air damper's stepping motor.

To fit

1.	Fit the mixed air damper's stepping motor into position.

2.	Connect the stepping motor's connector.

3.	Fit the stepping motor's link arm to the heating and ventilation unit's link arm.

4.	Fit the screws on the stepping motor.

5.	Fit the driver's acoustic insulation .

6.	Fit the floor console's front side panel.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.