Calibration of pinch protection
|
|
Calibration of pinch protection
|
The end positions and travel must be calibrated following mechanical work affecting the end position of the window, the replacement of the motor or door control module, or a loss of power such as when the battery is changed. Calibration must be carried out after all work involving removal of the door trim. Before the end positions have been calibrated, express closing will be disabled, which also means that the comfort closing and pinch protection functions will be inoperative.
Warning
|
|
The trap protection is not active until the window lifters have been calibrated after a power failure.
|
|
|
|
|
|
|
Note
|
|
Only one control module may be calibrated at a time owing to voltage variations.
|
|
3.
|
Open the side window about 15 cm.
|
|
4.
|
Close the window completely and hold the button for at least 1 second after the window stops.
|
|
5.
|
Press down the button and the window will now go down by itself.
|
|
6.
|
Wait at least 1 second.
|
|
7.
|
Drive the window fully up and hold the button in position until closing is confirmed with a sound signal.
|
