SAAB WIS ONLINE

Control module, door

Control module, door

To remove


1. Perform Preparations prior to removing a control module.

2. Remove the Front door trim .

3. Lay the side of the door on a clean and soft surface.

4. When changing the driver door module: Remove the cell block from under the door module.

5. When changing the driver door module: Remove door trim screw.


6. Remove the door module using a screwdriver. First undo the rear clip.

Then undo the clips on the outer and inner sides of the door module. Pull the module carefully back/down.


To fit

Note

Cars with pinch protection : If the door control module is replaced with M04- then the window lift must also be from M04-.

To distinguish the window lift from M03 and M04-, check the colour of the pulley behind the window lift motor.

M03 = White

M04 = Light brown/beige

Check the above in order to avoid the pinch protection incorrectly deploying.

The pinch protection can be deactivated using Tech 2 (version 127.000 or later) under the menu, Fault diagnosis - Model year 2003 - Saab 9-3 Sport (9440) - All - Service - Activate/Deactivate pinch protection.

This deactivation means that the "Express up" function is deactivated.



1. Fit the door module pressing it obliquely upward so that the clip engages.


2. When changing the driver door module: Fit the door trim screw.

3. When changing the driver door module: Affix the cell block with double-sided tape. The use of 16-30 20 807 is recommended.

4. Make sure the door trim clips are in place and intact. Replace the clips if necessary.

5. Fit the door trim .

6. Cars with pinch protection: Perform Programming of the pinch protection .

7. If the control module has been changed , perform Measures after changing the control module