SAAB WIS ONLINE

Rear widow lift

Rear widow lift

To remove


1. Open the window about 10 cm and fasten it with tape.


2. Remove the door trim and water barrier.

3. Slacken/remove the bolts to release the window.


4. Remove the window lift nuts and bolt.

5. Press out the window lift so that the studs comes loose from the mounting holes.


6. Unplug the motor connector.

7. Extract the rail at an angle through the opening.


To fit

Note

Cars with pinch protection : If the window lift is replaced with M04- then the door control module must also be from M04-.

To distinguish the window lift from M03 and M04-, check the colour of the pulley behind the window lift motor.

M03 = White

M04 = Light brown/beige

Check the above in order to avoid the pinch protection incorrectly deploying.

The pinch protection can be deactivated using Tech 2 (version 127.000 or later) under the menu, Fault diagnosis - Model year 2003 - Saab 9-3 Sport (9440) - All - Service - Activate/Deactivate pinch protection.

This deactivation means that the "Express up" function is deactivated.



1. Insert the rail at an angle and fit the studs into the mounting holes.


2. Fit the nuts and bolt.

3. Plug in the connector.

4. Remove the tape.

5. Lower the window to its mountings. Press the window down into the rubber lined mountings.


6. Tighten the window screws.

7. Raise and lower the window a few times to check its operation.

8. Fit the water barrier and the door trim.

Cars with pinch protection : Perform Calibration of pinch protection