Motor, electrically operated window lift, driver (164D)
Motor, electrically operated window lift, driver (164D) |
Location |
Motor, electrically operated window lift, driver (164D)
Main purpose |
Raise and lower the door window. Indicate the position of the motor (variants with pinch protection).
Type |
Connection |
Electric motor
The motor is connected with 2 wires to the door control module. (DDM)
Hall sensors
The sensors are connected by 4 wires to the door control module. The sensors have a common 4.7 V power supply and common ground. 2 signal wires supply each sensor with B+ via an integrated resistor. When the South pole of the magnet passes the sensor, the sensor shorts the B+ feed to ground.
The control module inputs are digital. A voltage greater than 2 V is regarded as "OFF" and lower than 2 V as "ON". The control module calculates the position of the window by counting the number of changes between "ON" and "OFF". The control module will count 2 changes per revolution of the motor from each Hall sensor. Since the sensors are displaced by 90°, the control module will detect a total of 4 changes, displaced by 90°, each revolution.
Motor without pinch protection
Pin number | Signal type | Description |
1 | B+ to open the window. Grounded for closing | Motor |
2 | B+ to close the window Grounded to open the window | Motor |
Motor with pinch protection
Pin | Signal type | Description |
1 | B+ to close the window Grounded for opening | Motor |
2 | Square wave B+/ground | Hall sensor 2 |
3 | Ground | Common ground for both Hall sensors |
4 | B+ to open the window Grounded for closing | Motor |
5 | Square wave B+/ground | Hall sensor 1 |
6 | 4.7 V | Common power supply for both Hall sensors |