T8 / P0719 00
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Fault indicator lamp (for further information see WIS Fault diagnosis, general)
Cruise control not working.
Brake Light Switch Circuit. Short to Ground.
Fault symptom
Fault indicator lamp (for further information see WIS Fault diagnosis, general)
Cruise control not working.
On-board diagnosis
Type of diagnosis:
Enable criteria:
| Battery voltage must be between 11 - 16 V. |
Fault criteria:
| No status change for the brake light switch when vehicle speed has been reduced from 40 - 3 km/h (25 - 2 mph) within a period of 2 - 12 s. |
| A DTC is generated if this occurs 4 consecutive times. |
Dependent:
System reaction to a fault:
| Cruise control switched off. |
OK report:
| Status change for the brake pedal switch has occurred. |
Fault handling:
| (See section Fault handling III, "Other emission-related components and functions" for more information.) |
Checking the wiring harness
Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.
Diagnostic help
Diagnosis regards:
| Electrical fault in connecting leads or component. |
| ____________________________________ |
| Fault in connector H42-2 is often a cause of this DTC. |
| ____________________________________ |
Functions in the diagnostic tool related to the fault:
| (See also description of readings/activations in diagnostic tool) |
